Printronix PrintCart Bedienungsanleitung PDF herunterladen (Seite 39)

Battery Subpallet (BSP) Removal

1. If the PrintCart is plugged into an AC outlet, disconnect the plug from the

outlet.

2. Open the rear access door.

3. Shut off the inverter/charger main switch located on the front of the

inverter.

4. Open the front door and disconnect the main battery quick disconnect

and hang it so it is out of the way.

5. Disconnect the display power cord quick disconnect and move it to the

side.

6. Remove the two side restraining bolts that hold the BSP in place. These

are located on the side of the PrintCart frame.

7. Obtain a pallet jack and center one leg of the jack approximately

18 inches under the BSP.

8. If using a pallet jack, lift the BSP about 1/4 inch and slowly pull back on

the jack to remove the pallet from the PrintCart frame. If the BSP gets

caught with the PrintCart, the lift may be either too little or too much.

WARNING

The BSP weighs between 150 and 230 lbs (depending on batteries

used). Be careful when removing the battery subpallet.

Figure 20. Battery Subpallet

Battery Subpallet

Pallet Jack

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 61 62

Keine Kommentare

Printronix PrintCart Bedienungsanleitung Seite 39