Printronix T4204 Bedienungsanleitung PDF herunterladen (Seite 46)

Chapter 2 Label Peel Off

9. Press the FEED key until the label liner is taut.

10. For automatic label peel-off mode, set Media Handling to Peel-Off in the

configuration menu. The Media Handling submenu is located in the

PRINTER CONTROL Main Configuration menu. See Chapter 3 for more

information on configuring the printer.

Close the printer’s front door and top (and side) cover.

Legend:

1) Peeled Label Area

11.

Press the PAUSE key to place the printer Online.

12.

Press the FEED key. A label should advance to the peel-off position

under the label taken sensor gate and “LABEL PRESENT Remove Label”

should be displayed.

NOTE: While printing a print job, do not press the FEED key with the ‘LABEL

PRESENT Remove Label’ message displayed or the message will be

removed until the PAUSE key is pressed. Also, each pressing of the

FEED key will cause a blank label to be added at the end of the print

job.

13.

Remove the label. “ONLINE” should then be displayed.

NOTE: A problem where labels drop back down onto the liner before they

can be manually removed can occur, causing the label taken sensor

to falsely sense the label was removed. Labels of 1.0 to 1.5 inches

long are more likely to demonstrate this condition.

This problem can be resolved by decreasing Print Speed or Setting

Paper Feed Shift (under the PRINTER CONTROL menu) from 0.00

inches to a negative (-) 0.07 to 0.10 inch value to retract the label

back slightly keeping it in the horizontal position under the sensor.

Peel-Off Mode

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 231 232

Keine Kommentare

Printronix T4204 Bedienungsanleitung Seite 46